Low Flame Spread in accordance with EU Directive for Marine Equipment. When used as part of an approved scheme, this material has the following certification: Tested in accordance with ISO 12944-5, C5-High environment 5, System 1, suitable for exterior exposure in Pre-qualification testing in accordance with NORSOK M-501, Rev. Prepared carbon steel, aluminium, concrete and galvanised steel substrates. Primer, mid coat, finish coat or as single coat system in atmospheric environments. Speciallyĭesigned for new construction where fast dry to handle and over coating times are required. It is a fast drying, high solids, high build product. This is a two component amine cured epoxy coating. Additional certificates and approvals may be available on request. Recommended for offshore environments, refineries, power plants, bridges, buildings and mining equipment. Colours grey, grey XO, red, buff, light red Typical use Other variants available Penguard Express MIO Penguard Express ZP Penguard Express CF Suitable for structural steel and piping to be exposed to highly corrosive environments, C5I or C5M (ISO 12944-2). 8 Consult your Jotun representative for details. Approved in accordance with parts 5 and 2 of Annex 1 of IMO 2010 FTP Code, or Parts 5 and 2 of Annex 1 of IMO FTPC when in compliance with IMO 2010 FTP Code Ch. Tested in accordance with ISO 12944-5, C5-High environment When used as part of an approved scheme, this material has the following certification: - Low Flame Spread in accordance with EU Directive for Marine Equipment. 5, System 1, suitable for exterior exposure in offshore environment, below 120 ☌. Approvals and certificates Pre-qualification testing in accordance with NORSOK M-501, Rev. It can be applied at sub zero surface temperatures. Suitable for properly prepared carbon steel, aluminium, concrete and galvanised steel substrates. Can be used as primer, mid coat, finish coat or as single coat system in atmospheric environments. Specially designed for new construction where fast dry to handle and over coating times are required.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |